Posted by Wheat47 on November 27, 2019 at 19:15:36 from (97.121.193.122):
In Reply to: Shoveling Oats Video posted by rusty6 on November 27, 2019 at 10:53:19:
Now, that was flat cheating to use the space heater!! I used to get an old greasy rag or glove, wad it up tight, wrap a wire tight around it, dip it in some diesel fuel and light it up. Then hold it under the oil pan a while, then under the carberator to warm up the air in the manifold. Usually worked pretty good. It was a bit hard to use a space heater when we were several miles from a current bush!! And I never caught an engine on fire, either.
Another old guy many, many years ago moved hay with a D-6 cat with a pony motor. He always had to move hay when it was 20-30 below., never when it was 20-30 above. So he'd take a motor like the one in the video in the house all night. Next day, he'd bolt the motor to the fender/deck of the Cat, put a belt from the motor to the pony motor starting pully. After got the pony motor going, eventually he'd get the diesel running. If he had to move more hay the next day, he'd leave the Cat run all night.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
