Posted by Billy NY on December 01, 2019 at 05:17:53 from (74.70.87.149):
In Reply to: Sawing Wood posted by rusty6 on November 30, 2019 at 19:21:00:
They were common around here, ones on the front of the farmall tractors as well as the Dearborn ones off the back, belt, PTO driven etc.
I have a CH & E sawrig that my father used here on the farm for smaller diameter wood and even wood from demolition, avoiding the nails. I used this thing last in the early 80's, and can recall how quickly he could buck a manure spreader load of smaller diameter wood. It's rated for 6" thick lumber. The shafts and belt sheaves roll free, nothing seize, though it has been out side but with something over the table top. I've got a nice 12 HP Kohler engine for it, original was outside too long, but actually still useable. This is a 60's era model, common on construction sites back in the day. I hope to get the engine in it at some point and put it back into use. This land is loaded with small trees that I would like to clear quite a bit of, could make a very large quantity of firewood from that alone, besides the larger trees I have an abundance of.
Interestingly, I found one of these sawrigs earlier this year, 4 cylinder Wisconsin, in very nice shape, had the fence with it, seller wanted $3500.00, a bit much but maybe worth it if I was to use it enough, passed, seeing I have one that would work just the same. I did save the photos of it off of CL, was going to post, can't find LOL !
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
