Posted by John T on December 04, 2019 at 06:12:49 from (107.77.217.80):
In Reply to: Light bulb question? posted by Gene Davis (Ga.) on December 03, 2019 at 20:29:01:
Gene, while its more common and typical to see standard screw in Edison Base LED replacement bulbs labeled something like light equivalent to say 60 or 75 or 100 Watt Incandescent, I have seen LED replacement bulbs labeled to replace a 200 Watt Incandescent. Sure they are a bit larger
NOTE when some people (especially non electricians or non sparkies) see older designed for Incandescent bulb light fixtures they may see a WARNING do not exceed 100 Watts !!!!
HOWEVER much of that warning concerns safety based on how much HEAT is produced (by an incandescent) or CURRENT is drawn...
BUT the LED replacement with equivalent lumens light output DOES NOT PRODUCE ANYWHERE NEAR THAT HEAT OR DRAW THAT MUCH CURRENT.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
