Drawbar type mower height is controlled by removable stops on the hydraulic cylinder along with adjustable linkage for the tongue.
For any drawbar hitch mower you'll need hydraulic remotes on the tractor, for a batwing mower it needs dual remotes.
I'm going to try to discourage you from the LCG models with some information.
LCG models get their stability by lowering the centerline of the tractor and making it wider, although they use different spindles on the front the rear axle height is determined by the height of the tire, of which only half of the tires height is added to the tractors overall height.
These numbers show that although the standard 4610 appears to be much taller than the LCG model it is in fact less than 7" taller at the axles centerline.
The rear tires on the AP model can be set to a wider stance than the LCG and will hold an additional 200 lbs of liquid ballast in each tire proving additional stability and traction.
I feel the low drawbar height of the LCG will severely limit the tractors overall usability. The low ground clearance will allow the tractor to easily become high centered and stuck on stumps, large rocks or in tire ruts, also any 3 point implement you hook to will be 7" closer to the ground at full lift height which could allow the implement to belly out on the ground went crossing a ditch or rut in the field.
Additionally those small 18.4-16.1 LCG tires cost around $200 more each than 16.9-30 ag tires and nearly twice as much as a SU models 14.9-28 tires.
After researching this info I now think your best option would be a standard AP (all purpose) model with ROPS, the tires and front axle spread as wide as possible and the tires loaded with liquid ballast.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Time Threshing - by Anthony West. A lovely harvest evening late September 1947, I was a school boy, like all school boys I loved harvest time. The golden corn ripens well and early, the stoking, stacking,.... the drawing in with the tractors and trailers and a few buck rakes thrown in, and possibly a heavy horse. It would be a great day for the collies and the terrier dogs, rats and mice would be at the bottom of the stacks so the dogs, would have a busy time hunting and killing, all the corn was gathered and ricked in what we c
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
