To test for codes all you need to do is cycle the key from off to on 3 times leaving key in on "run" on 3rd time. ( key pos: off/on, off/on, off/on). The ck eng light will flash 2 digit codes, first set of flashes is the 1st digit, then a pause, second set of flashes is 2nd digit. if see a code 12 first ( flash-pause-flash,flash) ignore this code, the final code will be a code 55 this code simply means the end of codes. An OBD-2 code reader will provide a better list of codes vs eng light flashes
If you are careful with a can of starting fluid you can spray it down the throttle body and see if it starts, that will at least tell you if it might be a fuel delivery issue, maybe pump, maybe something else. The best way would be with a fuel pressure test, if it has a test port it will be near the center of the LH fuel injector rail. you want to see approx 45-55 psi.
You can also check for spark by removing a plug wire and/or coil wire, no spark might lead you in the direction of ignition coil, other ign components or crank sensor.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
