Posted by MeAnthony on December 22, 2019 at 18:21:21 from (204.106.253.41):
My apologies up front to those who disagree with O/T posts. I understand your point but there's an enormous wealth of knowledge here on dang near any topic; no trying to twist anyone's tail, only want to learn from those smarter than I. :~)
So for a while my water pressure's been dropping to almost nothing before the pump kicks on. There was no air in the bladder tank; I doubt I've touched it since it was installed on about 2002. I drained system pressure, installed new pressure gauge and put 38 lbs of air in the tank, planning to adjust pressure switch to 40/60. Flip 'er all back on, it runs up to 70 lbs and shuts off. Ok, not what I expected but not terrible. Faucet running, it drops as expected to about 62 lbs; then a sudden drop, 3 or 4 seconds elapsed time, down to 40 lbs and the pump kicks on; runs up to 70 and shuts off. Repeat cycles are identical; the sudden drop to 40 lbs is noticeable in the water flow, so I'm sure it's not a bad gauge. But... I have no idea what would cause this...? Would someone please enlighten me?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
