Posted by Mutt and Jeff on December 24, 2019 at 12:00:36 from (64.222.86.31):
In Reply to: Compression VH4D posted by srollins on December 24, 2019 at 11:36:54:
New replacement long block assembly for a Melroe Bobcat Model's 630 and 730.For top mount distributor. Crankshaft at pto side sticks out about 7/8" from the face of the case with a 7/8" dia thread 12 threads per inch.
Description of a WISCONSIN LONG BLOCK ASSEMBLY
A Wisconsin long block is a low cost alternative to replacing the complete engine and is especially practical when all your external components are in good condition. A long block is manufactured by and supplied by the factory. Basically they make a standard engine production run and pull them off the line before they start attaching all the external components. This guarantees consistent quality.
A long block assembly is made up of the following components;
1) crankcase, cylinder barrels and heads 2) front and rear main bearing plates 3) pistons, rings, crankshaft, camshaft, valves, guides, etc 4) all is assembled complete ready to transfer over your old components and they include all the gaskets you require to install your magneto or distributor drive, carb, fuel pump, intake and exhaust manifold, etc.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.