Posted by Steve@Advance on January 02, 2020 at 22:01:14 from (66.169.147.211):
In Reply to: Melted fuse posted by ztw2009 on January 02, 2020 at 20:19:58:
Blower motors are notorious for doing that.
They pull high amps, especially when operated on high for extended times.
Often the motor will begin to draw more amps as the shaft bushings wear and the lubrication dries out. It may be time for a new motor, especially if it is rattling or squealing. Dropping it back to a lower speed will greatly reduce the amp draw.
What you can try to do on the bad fuse holder, take the fuse block out, turn it over. Working from the back side, find the wire that feeds the blower, cut it loose from the burned out terminal. Buy a heavy duty fuse pigtail from the auto supply. Look for the heaviest wire size you can find. Trim the wire back away from the heat damaged end, solder and heat shrink one wire of the fuse holder pigtail to that wire.
Then find the accessory feed wire that powers that circuit of the fuse block. Don't cut the wire loose because it probably feeds other circuits in the fuse block. Strip back the insulation and splice the other lead of the fuse holder to that wire with a good solder connection, tape it securely.
Route the fuse pigtail wires out from behind the fuse block, reinstall the fuse block so not to pinch the wires.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.