Posted by Billy NY on January 14, 2020 at 16:07:04 from (74.70.87.149):
In Reply to: Some Big Firewood posted by rusty6 on January 13, 2020 at 19:02:49:
Those blocks are pretty big all right and that is where an experienced climber is needed. I have seen it done quite a few times in recent years, larger trees, near structures, overhead wires or just do darned big, felling is not the best method or even possible. One down the lane here, they used a crane, tree service outfit did the work, 48" butt log. They chipped a lot of good limbs that I would have taken but I did get all the big logs. My friend had a large oak taken down by a single climber for under $2K, well worth it.
Some I have done are very tricky, but at this stage I know what ones to avoid, let the expert deal with it. I would burn all of that poplar or whatever, once dry, makes heat, so what, all burns and if you have a huge pile, why would anyone balk at that. I burn just about anything here, pine included and never have any creosote issues, just need to know what you are doing, season well, mix, use as kindling etc.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
