Posted by showcrop on January 15, 2020 at 05:21:29 from (75.68.37.174):
I had a visiting nurse visit for PT and general check-up yesterday following hip replacement surgery. The nurse is a nice girl in her mid twenties, and we had some good discussion. After awhile she surprised me when she asked when I anticipated getting out to work with my tractors. My first thought was "where does that come from?" I had not mentioned tractors and there were none visible. I explained that prior to surgery that it had not bothered me to get up on my Kubota which has a flat deck, so I anticipated getting out to do a few things before long. After some more discussion I asked how she knew that I had tractors, and she responded "from looking around" So I assume that she noticed implements, and perhaps some tracks in the yard. She than admitted to being an old tractor fan and going to the tractor pulls at the nearby agricultural fairs with her family pretty much every year, and how her dad has a Kubota and is always working around his place with it. So I showed her some pics and a video, and perhaps next visit we will get out to the barn and shop to see some first hand.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
