Posted by Ellis Kinney on January 17, 2020 at 09:50:36 from (74.138.166.55):
I bought an alternator and included bracket to convert my M to 12 volt and electronic ignition. I bought the electronic conversion kit from this sight even though it was a little more expensive than other places. The alternator for my tractor YT did not have. I ordered from DB Electrical. The bracket was the problem. It should have been a quick and fast installation. The holes were off where the bracket bolted to the head. I filled the holes in and re drilled to fit. The U shaped piece welded to the bracket that holds the alternator was put on crooked and the holes were off. I re-manufactured that part of the bracket and re welded. The part of the bracket that holds the adjustment arm was crooked. I ground it off and re welded. It took me three of four hours of piddling to get the whole bracket correct. This is the worst case of almost right I have ever seen. I would caution against ordering from DB Electrical, but lots of internet sites sell the same alternator and bracket. Ellis
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
