A blower is by far the fastest way to move deep snow. I use blower for every snow fall, even a 2" one. Way faster than messing around with a bucket or blade, and you can put the snow where you want it to go.
IH 80 (86") was IH model that fits, but any 7' should work. There isn't much to a blower. They do wear out in the fan after while.
I had bought an IH 70 (78") and replaced it with a brand new 78" shortline brand one, the new one works way better.
If you have your wheels narrow, a 78" might work. I found 78" blowers price more like a 72" (6') . 7' blowers were almost double the price of a 6' new.
Get hydraulic chute swing AND deflector if you have double remotes
Anyone slipping a clutch to use a snowblower shouldn't drive a tractor. If the tractor lugs down, push the clutch to STOP and let it clear. Idle down then fully engage clutch again then back to PTO RPM. Once you have a path made you can take part cuts. I often will carry the blower high on a first deep snow cut.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
