well. I'm a Case and OLiver fan so... It depends on what you're going to use it for since they are both good tractors and if taken care should give lots of service.
For general farming like some row crops and hay i would maybe look at the 1850 Olie as it may handle a bit better. if the oliver has Over/Under hydro drive that would be handy to have as well. The Case 930 can be a chore tractor too.. many are used in that capacity.
for brute force brunt work the Case long stroke engine can pull. The Case is probably a bit heavier than the Oliver too for heavy work.
They made alot of both models so Parts should be "easy" to find new or used but new are probably getting harder to find for both. Case still exists but they've cut back on alot of older parts.
the Perkins in the Oliver maybe be easier to get parts for as well since that engine was used in several applications and may also be available from Perkins too.
like others have said they are both OVER 50 years old now. try to get history, test drive look them over. when I've bought Cases in the past i've cracked the drain pan to look for antifreeze due to leaking sleeves. This is NOT a common problem but i have seen it. of course Not every seller would want you to do that either.
Ideally someone on here that owns both would chime in (i'm SURE there are a couple).
of course $$ is the other factor. so look at condition, tires, price and what you need it for and go from there.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
