Posted by sotxbill on January 30, 2020 at 07:24:12 from (104.5.24.112):
In Reply to: Starting problem. posted by jared 5 on January 29, 2020 at 11:44:08:
You had to pull the engine out,, or at least split the tractor to change the flywheel... and that means you probably disconnected the fuel system...
Timing in NOT a problem as the injector pump did not move as its tied to the front of the engine.
You did loose prime... so... fill the tank more than half way... so it will gravity prime. loosen the prime bolt on the filter assembly till clean fuel runs out with no bubbles...tighten bolt.. then loosen the bleed bolt on the ipump till clear fuel runs out with no bubbles.. carefully tighten this little bolt back up and DONT strip it on the pump...
If no fuel runs out on these first two steps, cranking will do no good.
Make sure the pump cut off lever is fully forwards.. and start cranking, but dont crank for too long and burn up the starter. let the starter cool down... if you loosen the injector lines at the injectors, when you start to see drops of fuel dribble a bit, you can tighten up the lines as you have most of the air out and crank some more. You should then start to see white smoke coming out of the exhaust as you crank.. This is the beginning sign your actually getting some diesel fuel into the engine. If very cold, you need to run a hair dryer on the intake manifold and into the intake manifold while cranking, to help it start... A thermo-start system may be on the tractor and help it start also. A bit of carefully applied ether... can greatly help but DONT over do it...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
