Posted by Goose on February 05, 2020 at 21:05:05 from (166.181.85.7):
In Reply to: 1990 Chev. odometer posted by Gene Davis (Ga.) on February 05, 2020 at 19:21:46:
This was a common problem on that series.
The odometer is driven by a little electric motor. Simplest is to replace the odometer, itself. The miles won't be correct, and if and when you get rid of the vehicle you'll have to sell it TMU. (True Miles Unknown). But, on that old a pickup the miles probably won't matter, anyway.
Thinking about it, though, I don't think the gear breaks, if I recall wear in the shafts and bearings causes the little gears to jump teeth.
Years ago, I bought an '89 pickup on an auction. The odometer showed 259,000 miles. When I drove it home from the auction, I found out the odometer was stuck on 259,000. I replaced the odometer with one that showed around 80,000. I rebuilt the body and used it for several years.
I finally sold it on another auction, and had the auctioneer announce that I had no idea of how many miles the pickup actually had on it, and even though the odometer read 97,000 it was actually more like 300,000. I still made money on it.
In fact, I ran across a deal on a 2000 Chevy that I couldn't pass up. The bottom line was, I upgraded 11 years for $1700.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.