Posted by TimWafer on February 15, 2020 at 05:59:52 from (98.21.118.93):
In Reply to: Vbelt sizes?? posted by TimWafer on February 14, 2020 at 07:05:28:
I went into the local hardware store last night and they have a whole wall in their back room with v belts hanging on it. We looked over the array of belts there and studied them for at least 20 minutes. I noticed that all the packages or wrappers actually list the actual outside circumference (OC) often in very small type somewhere on them. The belts themselves however do not. Some of these belts were obviously older than others as the store has been in business since 1943 .
Looking at all these belts I made the following observations.
Using a 65" OC belt 1/2" wide as an example size to compare.
Some are labeled 4L650 and actually say industrial belt next to that.
Some are just labeled 4L650
Some are labeled A63
Some are labeled A63/4L650
Some had a K after the designation which presumably means Kevlar
Some are labeled 6865 (these were Gates green belts)
Most of the newer looking stock had either the A63 or A63/4L650 designation.
I guess my only real question at this point is why the A63 type designation would go by the approximate inside circumference (IC) of the belt rather than the actual OC. The IC seems to be hard if not impossible to accurately measure either on the belt or the pulleys. Why add 2" to the designation of an A belt to get the actual size. That designation seems to defy all logic in my mind.Yet it seems to be what is dominate now. I must be missing something.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.