Posted by philip d on February 19, 2020 at 16:00:37 from (96.44.108.165):
There’s 52 in here right now. I run the corn silage in the center with the old 751 Bobcat. On Monday I cleaned both pens out, there was 7 1/2 tandem loads. There’s a bale feeder in each pen and we keep round bale silage in at all times. The first month this group of calves were in they got fed dry hay plus a little corn. On top of silage they get 6) 5 gallon buckets of rolled barley per pen per day. I still have some 40% heifer concentrate left and in each ton and a half batch I put in 400 pounds of supplement. I’m pretty near out of supplement so when I’m out I’ll add salt and mineral. Depending how far from home becomes my new full time employment will dictate if this is my last batch or not. I’ll have to decide one way or the other by June. If I have to leave for work every day by 7:15 and don’t get home till close to 7 I may not want morning and evening chores on top of that but I’ll see how it goes.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
