To me looking for FMCSA or DOT Approved/Certified is just like people saying "OSHA Approved". OSHA does not approve a hard hat from XYZ for example. They provide standards they want it to meet. The manufacturer is responsible to do what they need to do to meet and certify to those standards. OSHA oversees the use of the products, just as the FMCS/DOT does.
From the International Safety Equipment Association: "OSHA does not certify or approve any products. Any claim that a product is "OSHA approved" is misleading.
Product standards determine performance requirements, and certification indicates conformity to standards. How those products are installed and used in the workplace falls under OSHA.
OSHA standards and regulations may mandate the use of a product that meets a standard, but not specify how that product is certified. For example, the OSHA PPE standards require that hard hats, safety glasses and safety footwear meet specific ANSI standards; the OSHA respirator standard requires that products be NIOSH approved. OSHA officials often participate in the development of those standards, and ANSI and OSHA work in close cooperation.
For some products, such as electrical products in the workplace, OSHA requires third-party approval. When this is the case, it specifies the standards to which the products must be approved, and accredits test labs to certify to those standards. These labs are designated Nationally Recognized Testing Laboratories, or NRTLs. Keep in mind, however, that OSHA does not require third-party approval for PPE. Therefore no lab even if it is an NRTL should claim to be recognized by OSHA to test and approve PPE."
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.