2 things are for certain, no matter how you do it, with whatever splitter you have, is getting it up to comfortable work height and having a log catcher, cradle, table, whatever works to avoid working off the ground. I do not like just a beam, especially on a low rider splitter, granted you then have to get the blocks up onto the beam once it's at a good working height, so it is a toss up. we had a table for the Didier, lift up with 3 pt boom pole, then shield the exhaust away. Blocks were not too big, but it was better than being on the ground when there's lots of cords to be split.
I brought 3 loads of 6" average diameter elm up to the house, cut it up off the ground, well there's a 6 x 6 runner under it, to help the forks slide out easy. Back gets fatigued, I have an old gasoline engine powered table saw, need to put the engine in it. Once done, I will work from forks at height, to the table saw, to the cart with the small wood and that is extremely abundant, have not used it for this in 42 years or so, but like a buzz saw, it works pretty quickly. I used to work with my father using it, he would buzz off so much that he'd finish the cutting, I'd still be out there stacking an hour later LOL !
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.