"I did check the photo eye and it works the way it should".
By what means did you "check" the photo eye?
The way to check it (IF you feel you can do this safely, and at your own risk) is to temporarily bypass the flame safety control so the burner keeps firing and (using an Ohmmeter connected to the photocell leads with them disconnected from the flame control) monitor the cell's response to the flame.
Typically, you should be seeing a pretty steady 100 to 600 Ohms.
If the "eye" is weak or not "seeing" a BRIGHT flame, the resistance will be higher.
If the resistance is high enough (probably in the 1200 to 1500 Ohm range or more), it is NOT enough to keep the flame control "happy" and that's why it's been shutting down.
Sometimes, the eyes fail in the manner of their resistance rising as they warm up, that is why you need to monitor the cell's resistance over some time, and under actual operating conditions.
DON'T leave the heater unattended with the flame safety bypassed, run the test and then put it back as it's supposed to be.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.