Posted by notjustair on February 29, 2020 at 05:44:09 from (98.188.112.49):
I’ve had it without local Deere dealer. Had it! We’ve done business with them since the very first day they opened, but they have gotten too big and have no customer service left. They have also turned into parts throwers. I’ve always dealt with the owner and talked with him many times about the frustration - he always makes it right, but now he has 17 locations so he’s not there so much anymore.
Does anyone know of a good farm diesel mechanic that knows Deeres in northeast Kansas (specifically near Ottawa)? I run mostly aged stuff I’ve had since it was new, nearly new, or had many years - all Deere minus a few randomness. Everything from combines (a 9500), to an old 8430, a 4020, a 4440, a 7800, etc. everyone just uses the dealer here so I know of no one. The lawnmower just cost me a grand to “fix” and I still have to use ether to get it started if it sits more than a few days after it “needed” new coils. When I went to pick it up after the first time it wouldn’t start to bring it home and the mechanic got mad and picked it up with a forklift and then got to fix the deck height adjuster. It has 400 hours. My old Marty J mower with over 2000 hours starts no matter what. Everything that comes from them has to go back to get refixed and I’m tired of giving them tens of thousands of dollars a year for nothing but frustration. Anyone know someone?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
