The materials it's made from will always vary, but gradation, specific gravity and what it achieves for compaction, at optimum moisture content, (95% or better compaction) is a material that would be acceptable by a state's DOT engineer for sub base for a roadway, that would typically be the desirable material for a driveway. Take NY DOT approved Item #4, (what it was called for years) look at the gradation for it, so much percentage of a range of sieve size aggregate passing, all the way down to the fines, is how it's analyzed. It's a structural material, no clean washed stone is going to be structural, the same with sand, there is not enough of the range of different sieve size passing to create the correct density to achieve load bearing compaction at an optimum moisture content. I believe that although most of the NYS Item #4 I have dealt with was always processed from a stone quarry, it can be achieved from screened run of bank material. I worked for a small outfit that rant this material from a gravel quarry on their property that was some pretty good material once screened. I used it for structural fill, worked great.
It's going to be similar in gradation, just the natural materials will vary by location, best to use whatever the local DOT approves for roads. Same is true for concrete, DOT approved is often specified in construction specs, for a given compressive strength, because it's a tested and proven design for that material, wherever it may be sourced.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
