Posted by Billy NY on March 15, 2020 at 10:50:14 from (74.70.87.149):
In Reply to: Update on hay field posted by Grandpa love on March 15, 2020 at 06:30:09:
Been following this, smart move. Granted, starting small, testing the waters and putting that old equipment back to work like you mentioned, sensible way to feel your way through. I've got nice ground here for growing hay, but the odds are stacked in regards to pulling it off, no barns standing anymore, no hay equipment and I would have to start with new stands of hay grasses. What I do know is that orchard/timothy does very well here, there were so many great stands of hay around here at one time, I can't recall all of them. I'd do the same thing, start small, see who wants to buy, go from there. My goal would be to provide the best quality hay, and I'd probably take an early 1st cut, and subsequent cuts to cut down on volume for each being a 1 person operation. Those later 1st cuts can make some tonnage, gets stalky too though and even this small field by my house will produce 100 bales.
Some of my knowledge comes from putting up 3000-4000 bales way back when off this ground and another nice field a few miles away. I have not actually baled anything myself since 2009, and that was with my good friend and farmers operation, nice stands too. I used the same baler you have, a NH 315. It was a well kept one too, I should have bought it when they sold his equipment, very fair price and it performed great every year. Only trouble was with certain sisal twine, found that out when baling oat straw, quality of that twine that year was poor, kept breaking bales when they landed in the wagon, it had a thrower. Changed twine, problem solved.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
