Posted by Billy NY on March 19, 2020 at 05:54:37 from (74.70.87.149):
In Reply to: Burning uncured wood posted by 37 chief on March 18, 2020 at 20:46:49:
Not completely green if cut and split 3 months ago. I dont know much about Eucalyptus wood, but some species like black cherry, even recent dead elm will dry out considerably in that amount of time. Also consider where you are, not so cold or humid there, good drying conditions. Fresh cut and split will be much worse. Also, bring in the next round or 2 of what you'll burn, put by stove, will help immensely. That and keep the flue temp up, dont choke off the fire too much. I can mix in wood with higher moisture and never get any creosote to speak of. I wont burn fresh cut wood still laden with sap. My worst enemy is time, most of my wood is dead when cot, but with water moisture that needs to dry out. I can put pieces near the stove with no checking on ends and by morning is plenty dry. I've got numerous stacks of 8' sticks near the house that is small diameter to finish season, I cut and cover, bring inside a bunch, in a few days it's very good to burn, some is ready as is, other needs to dry, I mix, keep flue temp up and check my stack for excess smoke, adjust damper and combustion air accordingly or it will make lots of smoke. I am very attentive to not smoking out the neighborhood. Once a new fire gets going, it clears quickly, all about paying attention to the firebox
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.