Posted by Steve@Advance on April 07, 2020 at 07:57:22 from (24.182.105.128):
In Reply to: AC Delco Ramey Starter posted by Farmer Broome on April 07, 2020 at 06:19:29:
Not real common but it happens.
When the solenoid pulls the plunger in, it pushes the button inside the solenoid, closing the contacts to power the motor.
There is a spiral on the motor shaft that helps push the drive into the flywheel. That spiral in turn pushes back on the plunger. If the geometry is off, the plunger pushes too far back and the force of the motor on the spiral splines holds the plunger too deep into the solenoid, holding the button in, causing the motor to continue to run even with the signal removed.
It is caused by the wrong plunger, the fork bent or sometimes in backward, wrong drive gear, the thrust washer at the end of the drive missing, or the housing worn away letting the drive move too far forward.
I would take it back to the rebuilder. They will have heard of this before, should know what to do.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.