Sounds like a 5103 5203 5303 5403 5045E 5055E 5065E 5075E tractor with the 9x3.
I really considered buying one. There was a REALLY attractive price on the late 5203 / early 5055E that were 4x4 and 553 loader.
Nice solid, basic tractor, well built looking. Range lever is on the left (A B C) and speed lever is on right R 1 2 3.
Long story short, I test drove a 5055E 9F-3R, C range R is warp speed, A range is super slow, leaving B reverse as only real loader work option. I'm used to left hand reverse take some getting used to for me.
If you have a 2wd and need a 4wd and the price is right AND it's a flat top fender model, they are about as simple of a newer tractor as you can buy right now. Only electronic is the fuel shut off, everything else mechanical!
I'd still buy one if the price was right, but not as a dedicated high use loader tractor. I had planned to do mainly field work (loader off) and was upgrading from a 2wd.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
