Posted by Fatamus on April 13, 2020 at 11:04:54 from (72.35.100.25):
In Reply to: Chain Saw Help posted by Dave41A on April 13, 2020 at 09:37:40:
Hi my name is Fat Dan;
My experience with a chainsaw is I built a cordwood house two stories 3600 sqf. any way back to your problem.
All of these ideas are excellent advice and any one of them can be the problem. The Idea is to start off with the cheapest and easiest things first when troubleshooting. Which order you attack your problem is up to you; with that I'll give you some more areas to look at for trouble.
Today's gas has ethanol in it which has water, when fuel is stored over time the ethanol separates and the water accumulates. When fuel separates the system will gum up vital parts, e.g. high/low jets, diaphragm, float valve, filters.
Whisker in the spark plug: a whisker is when there short between the electrode and anode (piece of dirt in the gap). A bad spark plug can have broken porcelain, lose tip, fouled out or just used too much when it was new.
If the cloth type filter gets water wet it will not allow proper fuel flow.
USUALLY - If you take the carb apart you will find varnish left by the fuel residue has things block up. Simply by you removing the parts and cleaning them then replacing them gives the saw half a chance.
Hoses and gaskets: these little saws run on vacuum check lines and gaskets to and from and in the carb. Closely inspect the diaphragm gaskets/flapper-valves make sure they are clean and flexible.
A bad coil (unusual) can cause intermediate spark.
Spark Plug wire has short - pull over in a dark room and look for external spark.
Good Luck
Old pictures but gives a better idea of construction.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.