Posted by BlackAcresFarm on April 13, 2020 at 11:34:37 from (174.245.112.205):
In Reply to: New member from NC posted by BlackAcresFarm on April 12, 2020 at 18:43:19:
Quoting Removed, click Modern View to see
That s the bracketry for a sickle bar mower. The 801 has been a dedicated mower since it was new. I ll have to get some more pictures of it soon. I m in the process of getting it going again. Had it running, pulled the sickle up into transport mode, and the tractor died. During the process of trouble shooting, the solenoid has given up. I currently have the front wheels off to get the tires replaced this week. Then I ll pull it to the garage and start working on it again.
The 5000 was sold new with the M&W setup by Blue Ridge Tractor here in Wilkes County. My grandpa watched it work in a field (as a demo) and loved it so much he bought it. It s a 74 model. It was our original work horse. Both the 5000 and 801 are Select-o-speed. I ve seen a lot of good and bad, but I like the transmission personally.
The 5640 was also purchased new in 94 or 95 from Blue Ridge Tractor. I can t remember the exact year, as I was very young, but I remember the day it was delivered. I spent all last weekend going over both the 5640 and the 5000, cleaning, decreasing, and inspecting. Spring is here, and it s time to work!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
