Posted by Hobo,NC on April 18, 2020 at 09:16:54 from (75.137.54.87):
In Reply to: Friday in Alabama posted by Grandpa love on April 18, 2020 at 04:18:34:
To high it will take care of itself : ) its the nature of the beast...
8" is close enoufh...
The adjustment on the control valve...
I see a boat load of exposed threads that will push the control valve in rather FAR = your to high issue its bottoming out way before the quadrant reaches top of travel ... As you shorten the link it will make the lift drop lower (control valve able to move out farther)
If you ever go back into it you can work the quadrant and see how it functions... Don't get caught up in all this adjustment garbage its rather simple LOOK at the control valve where its at at the upper and lower limit in relation to the quadrant and how it feels...
Once satisfied run the adjuster out 2 to 4 turns life will be good...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
