Posted by Lyndon - AB on April 21, 2020 at 16:10:26 from (72.172.118.156):
In Reply to: high rpm massey 444 posted by 444masseyharris on April 20, 2020 at 19:09:25:
Crazy Horse, our tractor pull must be high class then, we get metal trophies! Lol, just ribbing you. One of the reasons I like pulling with my Oliver 990 - it sounds fast, but its not going to hurt anybody in stock form. Except maybe hearing, but hey, I did my part and put the muffler back on it! :lol:
To the OP - to each their own. Personally, what I like most about the old Masseys, is not what they can pull with huge RPM, but what they can pull with the last few hundred RPM. Surprisingly potent luggers, those 4 cylinder Masseys.
The other posters have better explained the process of making a puller than I can. I will say though, there is a very good reason for all the safety cages/shields on super-modified pullers. For every piece of safety equipment/rule, someone has a been hurt or killed. Bear that in mind.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
