Well, don't do like my BIL did. He paid some guy with a bobcat to prepare his polebarn site on the side of the hill. All the guy did was to scrape off the topsoil. I told my BIL that it was no good, but I'm guessing he didn't want to pay what it would cost for a proper site prep. When we set the posts, the low side was like two feet lower than the high side! He had to splice some extra length on to one of the posts just so he had something to nail the girders to. There was a foot gap under the rim boards he had to close off with lumber. He never did bring in any fill to level it off. He would have water standing anytime it rained. He eventually sold the property; I sure the new owners have had fun trying to straighten that mess out.
When I built my shop, I picked a fairly high spot and had sandy fill brought in. I compacted the fill as best I could with my tractor and a vibratory compactor. It's been almost twenty years since I poured the floor, and there's not a single crack in it. I have good drainage on three sides and OK drainage on the door side. Time and money spent properly preparing your building site will pay off many times over.
It sounds like you're going to put brackets on the floor and attach your posts to them. That's OK, but those posts have a LOT of weight on them and the floor has to support them if you don't make footings. Do the math on how many pounds of roofing each post has to support and I think you'll want footings.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.