Posted by knightstead on April 25, 2020 at 13:08:37 from (99.82.253.222):
I'm getting closed to having the inside of my shop finished and getting to the point where I need to get a plan together for my lean-to. It'll be 44 feet long and I'd like to make it as wide as possible, hopefully 21' or 22'. The shop has a 4/12 pitch and I had the builder put up a ledger board on the end of the trusses to make things as easy as possible. I can't continue the 4/12 pitch since the side wall will be too low (ledger board is 13' off the ground). I was planning on a 3/12 pitch and spanning the roof with 2x10 Southern Yellow Pine rafters (24' long) on 16" centers. End wall would be 18' from shop wall to help with strength, the other 3'-4' will be overhang. My father in law thinks this is not suitable, and he's very knowledgeable on building, so I do value his opinion. His suggestion is to install mono truses since they are engineered to carry the load and he believes the 2x10's will sag over time. I've priced both options and the trusses are over $1750 and the rafters will come to roughly $1400. Has anyone spanned that far with rafters and how well has it held up? Building is an hour southwest of St. Louis MO and we do get some snow, but typically nothing to get excited about. No building codes out there but I would like to build this thing right the first time. Thanks for any and all input.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.