Posted by rockyridgefarm on May 02, 2020 at 06:55:05 from (166.182.250.209):
In Reply to: cleaning oats posted by Charlie M on May 01, 2020 at 11:24:23:
Picture of the cleaner would help a lot. Some fanning mills don t allow for screen changes.
Newer screens are perforated sheet metal. Round holes are generally measured in 64ths, so a 24 has 24/64ths holes. Slotted are measured width in 64ths and stated length, so a 10x3/4 is 10/64ths wide and 3/4" long. Smaller holed screens can have the full measure printed on them, 1/12x1/2 is 1/12" wide by 1/2" long.
Depending on the size of your oats, you will want between a 20 and 24 round on the top (scalper screen), and around a 1/12x 1/4 bottom (seive screen). It is not really exact, something close will do the trick. You will also want to either slow the speed of the fan or baffle the inlet to get less wind. It depends on what kid if job you want to do. If you want only the best seed, keep the air more and get more out on the ground, if you only want to clean it enough to get it thru the drill keep the wind low to only blow out the chaff.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
