Posted by Plant Doc on May 02, 2020 at 12:14:27 from (73.196.97.0):
I am working on neighbors 2950 with cab. The hydraulic clutch stopped working so I opened the bleed on the slave cyl to see if it had air in the system. No air and no pressure. I put a new clutch master cyl on, bleed the system and still no clutch and no pressure. There is a 1/8 line from the slave cyl to the bleed on the Hi Lo trans. Opened that bleed and got plenty of hyd oil but no pressure. I am more than sure I have all the air out of the system. If the slave cyl was bad I should see some leakage but I do not see any. But I do not know where the hyd oil goes on that HI Lo system. Could I be losing pressure somewhere on the HI LO and how do I determine I do or do not. My IT shop manual says to bleed the HI LO bleeder but says no more about it. It doesn't even show anything about the HI Lo and I do not want to start ripping into things without having an idea what I am doing. Can I simply plug the line going to the Hi Lo and get the tractor working just to get the corn planted. I don't care if the HI Lo doesn't work just to finish the corn. Any info will be appreciated.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
