Posted by caterpillar guy on May 09, 2020 at 18:24:19 from (47.26.95.42):
In Reply to: Combine drivers posted by smalltowner on May 09, 2020 at 08:19:22:
I ran the wheat harvest 5 years with 3 different cutters. One for 3 years. I was older than most of the crew each time. The guy I worked for 3 years,I worked in the shop from March till we left to go south. Start at Kiowa KS go to Munday TX then worked north. Always liked it in the MT and ID areas best. Went as far north as Dubois Id then go back to Blanca CO to dig spuds cut wheat and pickup barley. Would get done about Thanksgiving. Then haul The machines back to either Kiowa or the dealer he traded with. 10 combines,3 grain carts 1840 and 2 1240 Kinze's. And the trucks to keep up. When we moved it was like a cattle drive first guy would be in TX and the last was leaving KS.LOL Not quite but close it seemed some years. Another experience is digging sugar beets. Did that for 5 years also.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
