Posted by caterpillar guy on May 20, 2020 at 03:12:53 from (47.26.95.42):
In Reply to: Bozeman, MT posted by Thehickdaddy on May 19, 2020 at 10:01:31:
IF the Wheat Montana your talking about is the place I've seen it is at Three Forks not Livingston. Livingston has the Yellowstone truck stop on top of the hill west of town. Wheat is on the north side of the interstate with a truckstop on the south side. Then go over the hill to Whitehall. A nice scenic drive is across US-12 from south of Missoula over to Lewiston WA. Then you can drop down to Pendleton OR from Walla Walla WA take Or HWY 11 through Milton-Freewater This will put you out to I-90 without having to go down the hill from LaGrande If you get close to Grangeville ID stop at the Deere dealer and see if Ted is still around. He has a fine collection of tractors including some old odd stuff. There was 2 models Yuba tractors some old Caterpillars and lots of wheel tractors in 2 different sheds there. There were also a few Cats setting around the Deere dealer lot he owned. I was there 6-7 years ago. He was in his late 70's or 80's then. I think he told me the Yuba's were a friend of his pieces. Might even be able to check with the dealer ahead of time to see if it is all still there.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
