Posted by Jim.ME on May 20, 2020 at 04:28:22 from (67.242.176.27):
In Reply to: Bush Hog PTO Shaft posted by knightstead on May 18, 2020 at 15:28:37:
Quoting Removed, click Modern View to see
Looking at shaft in the Amazon link you posted, the slip clutch end has the same spring loaded lock pin as the tractor end. Does your Bush Hog gear box have the groove around the shaft for the spring loaded lock pin?
The Bush Hog parts break down shows a 5/16" bolt through the shaft, not 1/4". The two 5/8" bolts clamp it tight to the shaft. Here is a picture of the slip clutch and rectangular shaft on a 307 Bush Hog that is like the one the parts book shows for yours. The bolts through the shafts are all 5/16".
Repairing your shaft is a good option. If you want to add a slip clutch pricing a complete shaft with clutch should be done. The hole for the 5/16" bolt can be added with proper layout and care.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
