Posted by RedMF40 on May 21, 2020 at 08:42:51 from (172.58.188.0):
So I picked up this assortment from a retired welder. I bought it for the welding tips. I'm a little scared of that big red fuel gauge. Not feeling great about the O2 gauge, either. Would an experienced welder risk using either of those? Also, should I put a flashback protector on the fuel side of the torch?
I know, most everyone has gone to electric welding these days, but I have an oxy-acetylene outfit already so that kind of dictated my current choice. Currently doing some light welding/brazing. Nothing structural.
Oxweld. I did some research before buying, many on a welding site thought it was a great brand. I've never heard of it. Not like Victor or some of the other big brands. I'm into all this for $120 and I am probably the only person who would have paid that but if the tips work I guess I'm ok. Thanks for any advice. If I should put some of the pieces on the shop wall "museum" I'm ok with that.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
