There was 40 acres of oats in the crop rotation on the 160 acres I grew up on. We used the straw, the actual oats we added to hog feed to reduce the amount of shell corn we had to buy. We needed 20 acres of hay for baled hay for the cattle, and 20 acres of hog pasture. Combined originally with two #62 IH pull type combines, both with the Continental 69 cid engine. One to run, one for parts. A Deere #25 replaced the IH's, but still had canvases. Took a while but about 1968 Dad managed to talk the neighbor, a salesman at the local Deere dealer out of his #30 Deere. Every year, about a week before oats were ready to combine a big thunderstorm would blow thru. And good oats would be flat on the ground, 1st gear with TA back on SM-TA or 450 was too fast. Where oats were light and where standing you could run in 3rd gear! One neighbor always made a BIG deal about baling his oat straw quickly because it made better bedding for his hogs. So one year we had 20 acres right next to the buildings, I had enough time to hook up the hay rakes and after unloading a load of oats in the crib I would rake a couple rounds around the oat field, two 7 ft rakes hooked together, raked first pass "IN", second pass "Out" to complete window, 28 ft in a windrow, only about 12 rounds around the field. Dad only cut the oats right under the heads of the oats, barely enough straw to see with just a single 7 ft pass with the rake. I was done raking about a half hour after Dad was done combining.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.