Super, thanks for the shout back, FYI There's NO WAY anyone who hasn't taken any measurements, who hasn't analyzed the soil, who hasn't tested the effectiveness of the "ground" in accordance with well settled NEC requirements
CAN TELL YOU WHETHER OR NOT THAT EXISTING GROUND ROD, AT YOUR LOCATION, IN EARTH THERE, IN YOUR JURISDICTION, IS SUITABLE OR NOT IN ACCORDANCE WITH ANY APPLICABLE NEC REQUIREMENTS (if such even exist there or applies to your exact case ???) give me a break !!!!!
Way back when I was a power distribution design engineer and current with the latest NEC in our jurisdiction WE were required to drive the FIRST Ground rod,,,,,,,,,test it,,,,,,,,,,if it failed we had to move x feet and drive another then test the combination,,,,,,,,,,BUT IF IT STILL FAILED WE WERE NOT REQUIRED TO DRIVE A THIRD. Maybe other jurisdictions may other codes may have been different requirements
Super, You ask great questions and are trying to learn and no offense meant towards you but likewise your "guessing" "the ground rod doesn't do any good" may not have much affect. Guessing wrong can get someone killed, I wouldn't take any advice based on guessing (even your own) when fire and life safety is concerned INCLUDING MINE not being there and no idea of your ground and having taken no tests and how your genset is configured and its use.........
NOTE the electrical quality and NEC testing and requirements of the ground where the existing rod is driven (if it even applies or matters, Im NOT saying I have no idea) and whether or not its even required or not ARE NOT THE SAME THING.
Take care, be safe, best wishes I'm not scolding, I'm here to try my best to help, I'm ONLY saying just because someone "guesses" or who claims the rod at your location in your earth is good or bad, having made no tests whatsoever, DOES NOT MAKE IT SO. For all I know it may be right it may be dead wrong, your risk your choice........
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
