Posted by Janicholson on June 07, 2020 at 13:46:41 from (24.240.46.228):
Bolt pain. My neighbor came to see me about a IH 160 PU water pump. It had about 1/2 inch play in the tips of the fan blade, but didn't leak. One bolt was going to twist off $ 3/8 course bolts hold it on. I was sure it was going to fail, but PB blaster, and good feel for bolt deformation compared to rotation helped. The backing and forthing for 15 minutes starting with 2 degrees, and incrementally increasing the rotation worked. The bolt head finally rounded enough to nearly strip corners, so I got a 14mm and pounded it on to the hilt. That was superior in that it was solid. The bolt head was transformed to metric. 2 pound hammer made a good impact die out of the Herbrand wrench. The bolt eventually became 20 degrees free, then 30, then 180. Each time going back to start. We then got a 14 socket on it when it cleared an obstruction. The pump unscrewed from the block (the water pump was flopping as the force was applied. The bolt had rusted into the water pump housing and was bound there, not in the threads. The housing is about 1.75 inches thick where the bolt was located. He now is arranging for 24 Summit Extra Pale Ales delivered. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
