I have to agree if you can't say something constructive or helpful why comment. Like the poor guy that got beat up just because posted he wasn't going to barrow anything anymore after he had a flat tire. I've been on here well over 20 years and will just usually comment rather than post anything. Seems like everytime I did, back when, I'd get at least one snide remark or rude unconstructive comment. Although on line you don;t know the full intent of the comment like you would sitting in a coffee shop where you could tell if the person was just kidding a little with you. I miss some of the ones that were always helpful on here that got fed up and left because of the comments of just a few. Although there is a few that have left that I don't miss. There are some post when I read them I think here we go, somebody will sure beat this guy up over his post although I think some do just post something that they know will get someone fired up.
I will say I've yet to meet anyone on here in person at one of our lunches or a tractor show that I didn't like or didn't enjoy talking to.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
