I can't think of a bad tractor that was commonly available in 1949. They were all good tractors. With our heavy land, steep barn hills, heavy loads, etc, we would not have considered a Ford 8N. However, my uncle, on his level, sandy loam seemed to get along fine with the Fords of that day. They were great little tractors with emphasis on "little". We called them "garden tractors" before there was such a thing. Next door neighbor bought a 1949 John Deere A, gas burner. Needed more power. We bought a 1949 WD Allis Chalmers. Already had a 1936 WC which was a good tractor and my dad had become good friends with the dealer. We had a lot of John Deeres in the neighborhood mainly because of financing (the banks were run by scoundrels, still are) but also because they were quality products. Farmalls were around but not many because the nearest dealer was less than honorable. Same with Minneapolis Moline. Massey Harris was a favorite because the dealer was popular and would cut you a deal that was nothing less than spectacular. He was also a Chrysler dealer with all the lines (Plymouth, Dodge, DeSoto, Chrysler) but could get you a brand new Cadillac cheaper than any Cadillac dealer. Oliver was too far away but there were a few around. Of all the tractors I can think of, I think we would have been best served, at that time, with an Oliver. Powerful, smooth running, comfortable, dependable, affordable what else is there? Hard to put the cultivator on and off though. Something Allis Chalmers perfected early on and John Deere, with their quick tach, followed.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
