Posted by Mike(NEOhio) on June 26, 2020 at 13:01:25 from (72.16.0.132):
In Reply to: My hips are worn out posted by Keith Molden on June 26, 2020 at 12:22:16:
Keith, don't stress about it. I had both mine replaced in 2009 and 2010. It was three days in the hospital and you're walking the same or the next day. I was back to work in six weeks and stacking the wagons in three months. I'm recovering now from having the first one redone on 6-8. The ball and liner wore out and the upper cup was loose. The other side is the same and needs repaired too. This time it was only an overnight and with a little help walked to the head a few hours after. Home the next day and they sent a therapist the my home, twice a week for three weeks but that will vary by patient. You'll need a walker or crutches for a few weeks but less and less each day. Therapy isn't bad, just do what they tell you. My mom had a hip done at 92 and did fine. You'll have to restrict motion for the first month. Can't bend past 90 deg. or any twisting motion or crossing your legs. Unless the doc uses the anterior approach, no restrictions, mine doesn't. After a few months you'll forget it was ever done. As to deciding to do it? No question...DO IT. It's what I tell everybody who asks me. You only suffer and it will not get better. Pick a good surgeon, one who does these A LOT, not a few each year. Personally, I wouldn't rely on the VA. I'm not a vet so it's only my opinion but from things I hear I'd be skeptical. I hope this helps. I was apprehensive the first time. The second I said schedule it as soon as you can.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.