Posted by pobo6 on June 29, 2020 at 07:46:35 from (97.92.182.138):
The son's been working on a couple of tractors; a Massey Harris 20 and a Case DC. Both tractors use a 5/8" belt for fan, generator, etc. Wanting to convert from generator to a 12 volt 10si 3-wire alternator system, but cannot seem to track down one that has a pulley that uses the 5/8" belt. Been to several parts stores, including NAPA; got the "deer in the headlights" look from all parts people when I tell them we are converting to alternator, as it's "not in the computer" (no surprise there). I truly miss the days of old-timers in part stores that knew what you wanted and retrieved items from shelf without looking at the old books.
Those of you that have accomplished it, where have you found the elusive 10si 3-wire alternator equipped with 5/8" width pulley, along with a part number(s)? I see a lot of the one-wire alternators with the 5/8" pulley available online, but that is not what we want. I've even inquired about swapping pulleys out, but get the same "what model is it for" response which is moot as they don't understand the concept. Thanks for the help!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
