Posted by Janicholson on June 29, 2020 at 18:06:58 from (24.240.46.228):
In Reply to: OT - Nail Pop? posted by npowell on June 29, 2020 at 15:33:04:
Agree, a cautious attic reconnaissance is first. clean it from that side. If insulation is present, use gloves and try not to disturb it very much. Once the attic look see is done, put down a tarp, or plastic, and pull down the broken pieces. if the material is plain sheet rock and the home is going to be an investment, I would remove the entire ceiling, and put up new Cement backer board. This material can withstand the high moisture around a shower. If a good temp repair is needed, and the remaining material is solid, take a piece of 1/2" plywood that is 2" overlap of the hole. Glue it down with Construction adhesive. Cut a piece of sheet rock close to the hole shape (or moisture resistant rock, or cement board) put the piece up in the hole, and use 6 or 8 coated (rust proof) to hold it in place (put the screws in just a tiny bit below the surface). Use a product called Durahm's rock hard water putty as the compound. It will be water proof when set, and solid. It can be sanded. prime and paint the entire ceiling. I hope this helps. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
