Posted by Texasmark1 on June 30, 2020 at 06:32:01 from (172.243.92.145):
In Reply to: OT - Nail Pop? posted by npowell on June 29, 2020 at 15:33:04:
My bet is it could be foundation shift. I'm on black clay....mud in the winter (soil expands), rock in the summer (soil contracts). It seems, like happens to me after 42 years, as the foundation moves around the outer walls, supporting the free span (in some areas but not in others affected like this) trusses move at one rate and the piers supporting interior walls move at another. As a result, every season it opens and closes the cracks in the sheetrock and ceiling attachment devices open and close. I used to crawl under the house simi-annually and adjust. Too old for that now, just watch 'em open and close.
I agree that it should be sealed, being in the shower.
I also have a good deal of insulation in the attic weighing on the rock and in the free span areas I have had to re-attach the sheetrock to the trusses as it has started sagging gapping off the trusses as much as an inch is some areas. I use 2" sheetrock screws and 2" flat washers. Work a section tightening the screws a little at a time till I get it back up against the trusses.....distributing the weight across a larger area than just one screw as I go.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
