Posted by Robert (ID) on July 19, 2020 at 18:50:31 from (174.208.1.186):
In Reply to: Walked home posted by David G on July 19, 2020 at 17:38:45:
Yup, yesterday in fact..
It was the walk of shame or the call of shame.. had dads 841 and the small 6ft 3point disk.. I was disking ends and fence rows. I had backed in along the fence to get lined up on some thistles, put it in 2nd dropped the disk I went about 300 yrd and hit a wash out... Off the edge into the fence and the disk caught the 45 yr old wooden post and there I was sitting on about a 45 degree angle and wondering WHAT THE HE(( just happened.. OK, do I try to waller it out and end up going clear thru the fence or?? it took me about 5 seconds to decide to dial the phone.. Dad answered with "what did you break and where are you at." he brought the 3010 down and pulled me out. I only had to replace one post and re-stretch 3 wires. It never happens close to the house..
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
