Old sofa bed was worn out and Son and granddaughter were visiting from Montana in January while I was having my gall bladder removed so I decided that I must buy a new sofa bed. Long story.
I hate buying furniture because I know little about such and always pay too much for the wrong stuff.
When in the house watching TV, etc., I would sit in the corner of the old (good but worn out) sofa bed with a pillow between me and the arm rest. Doing so made my back hurt.
Went furniture shopping and bought a new (not so good but new) sofa bed to replace old one.
Visit went well but new sofa bed hurts my back more than did old sofa bed while watching riveting TV, so decided to buy matching (while I could still get matching) chair so as to position chair such that I could watch TV, etc., directly rather than obliquely while sitting in corner of sofa bed. Was really raped by furniture store on chair because by this time they knew too much about why I was buying it but ordered it anyway.
After receiving new chair and positioning it, realized that I now needed an end table for lamp, clicker, phone, etc., so back to furniture store. Raped again but did get decent end table for about twice what it should have cost.
New chair hurts my back more so than does new or old sofa bed.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
