Also, i have been looking into the idea of replacing the motor with a good used 3-53. However, from what I can tell by internet research, there are 8 different models of this motor with some even having different rotations of clockwise or counter clockwise. Also, the Exhaust, and Air Pump, and starter, etc with all different variations in different locations. I have a RH starter and Exhaust, LH Air Pump, and I believe its a clockwise rotation but ill have to verify that today.
My question is, will any 3-53 work no matter which rotation and which side everything is on? Or do I have to have a clockwise rotation with a RH Starter and exhaust and LH air pump? Could i take and 3-53 and just bolt it up and it works? Will the transmission work no matter which direction the motor rotation is? Will the Hyd. Pump work no matter which direction the motor rotates?
Im not even close to being a mechanic but it would be alot easier and quicker if i just swapper the motor although the problem with this one could be cheap and simple repair(???)
Thanks everyone, I appreciate your input and advice!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
